Pick the chalk line up pulling it.
Drywall over cinder block wall.
Cut the nozzle end of a tube of construction adhesive at a 45 degree angle using a utility knife.
Make marks at either every 16 inches or every 24 inches.
Frame out the rest of the wall by adding faux top and sole plates dropping the top a bit for a drop ceiling if.
The hat channel image 1 should be attached to the wall using concrete nails and concrete nail gun images 2 and 3.
Furring strips come in.
Using a scraper scrape off chunks of debris from the wall to make it as smooth as possible.
Add some rigid board insulation between the hat.
Attach the drywall to the furring strips with a nail gun and one inch drywall nails.
Use concrete nails and a concrete nail gun to attach the hat channels to the wall after drawing a plumb line to make.
How to glue drywall to the interior of concrete block walls.
Measure across a wall both at the top and bottom.
Stretch a chalk line from the first top mark down to the corresponding bottom mark.
These correspond to the typical.
Install vertical furring strips every 16 inches on the cinder blocks using concrete screws to hold them in.
Poke the foil cover at the.
Drive three concrete nails spaced at even intervals through each side of each hat channel.
How to put drywall over cinder block step 1.
Repeat for all drywall sheets.
Begin in an upper.
First draw a plumb line to make sure the hat channels will be spaced properly for the size of drywall and insulation you re using.