Do Prime And Paint Cut Ends Of Truwood Siding

According to the terms of lp s application instructions all exposed edges of lp smartside siding and trim must be primed and painted with approved paint to protect the siding substrate.

Do prime and paint cut ends of truwood siding.

Therefore do not prime the back side of the siding or trim. Make sure to prime and paint all exposed cut edges. 2018 2015 2012 2009 international. Once the siding has been installed apply two coats of a top of the line latex exterior house paint to it.

Cutting cut with conventional tools into the face to be exposed. Use high quality waterborne 100 acrylic exterior paints apply a finish coat within 180 days of installation do not paint wet siding ensure the surface is clean dry and free of any dust dirt or mildew do not use. Watch this video to find out more. Do not bevel cut the siding edges at butt joints.

Truwood siding meets the requirements of the following codes and standards. Make sure to prime and paint all cut edges. All it takes is a little can of paint or sealer. Clearance between the gutter end and trim see fig.

Back priming helps prevent paint from peeling by reducing the amount of water vapor that passes through the wood. Priming and sealing end grain during the wood siding deck or trim installation can be easily accomplished and does little to slow down a job. Provide a 1 in. When back priming be sure to prime the ends of each piece after it has been cut to fit since end grain will absorb the most moisture.

If trim is cut to fit around door and window openings raw edges. Spray cans or primer or disposable cans and brushes with primer can be used to prime the end grain once installed. Do not paint in wet or cold conditions. Additional primer is not needed field painting guidance for best results with our primed siding products.

Roof and gutters are adjacent to the siding.