High loop to garbage disposal follow the same instructions as 1 except connect the dishwasher drain hose directly into the garbage disposal.
Dishwasher drain hose installation garbage disposal.
The drain system includes an air gap fitting that prevents garbage disposal debris from.
The dishwasher pumps discarded water and food particles through the hose and into the garbage disposal.
A dishwasher drain hose can be connected to garbage disposal or can be directly configured in the drain line.
Air gap to drain after mounting the air gap device to the sink or countertop you ll attach the.
It is recommended to connect it with garbage disposal because as the dishwasher pumps the discarded water and leftover food particles in the garbage disposal the garbage disposal can grind the food particle and push them down the drain.
Connecting a dishwasher drain hose to garbage disposal.
Drain connection with air gap and garbage disposal.
The factory drain hose on the dishwasher which runs from the dishwasher to the smaller of the two tailpieces on the air gap and a 7 8 inch inside diameter hose that runs from the other tailpiece on the air gap to the dishwasher nipple on the garbage disposal.
Dishwasher drain hoses can be connected to the garbage disposal in different ways.
However if you were to connect the dishwasher discharge drain directly to the disposal and loop the hose high up underneath the counter and experienced a blockage it wouldn t go back down to your dishwasher.
The air gap works by allowing fresh air into the drain hose if there is a backup causing negative pressure.
If an air gap fitting is used there will be two lengths of drain hose.
The incoming dishwasher drain hose connects to one fitting while a secondary hose runs from the other fitting to the kitchen sink s drain pipe or garbage disposer.
Food will eventually get trapped in the dishwasher drain when it does you experienced this problem of your dishwasher not working properly.
Before connecting the dishwasher and the garbage disposal you will need to insert a screwdriver into the nozzle of the hose and use a hammer to gently push out the knockout plug into the nozzle.
When the disposer is turned on it acts like a pump and has the capability of sending dirty water back to.